Snappi Nappy Fastener - Grey

R 13.00 – R 36.00
Shipping calculated at checkout.
Looking for a better alternative to diaper pins? Look no further than the Snappi® diaper fastener! This nifty little fastener is a hygienic and easy-to-use way to fasten diapers. The Snappi® is much faster than traditional pins and provides a secure, balanced fastening for high containment. But be sure to use the Snappi® responsibly and correctly for best results. Follow our stretching instructions before first use to activate the Snappi®'s "memory" and ensure a snug, comfortable fit.
People are viewing this right now

Choose Packet Pieces: Choose an option

1 Piece
2 Pieces
3 Pieces
R 19.99
Order in the next [totalHours] hours %M minutes to get it between and

Size 2 Nappy Fastener.

Get hooked with the nifty little fastener that replaces the pin! The Snappi® diaper fastener offers an easy and hygienic way to fasten diapers. The Snappi® fastener is much faster to use than pins and provide a nicely balanced secure fastening, which gives the nappy it is used on, a high degree of containment.

Snappi® fasteners must be used responsibly, and need to be used correctly in order to work effectively.

Stretch the Snappi® fastener before its first use. The stretching triggers the ‘memory’ of the Snappi® to return to its original size, and in doing so, will pull the diaper to the middle to allow for a snug fit. It also makes it more pliable/elastic and therefore easier to use. This is essential for the Snappi® to work properly.

Stretch the Snappi® by holding it in the center with one hand and with your other hand, grab close to the end of one of the arms, avoiding the sharp teeth, and pull. Do not grab the Snappi® by the loops. Repeat this about 10 times for each arm. You will notice the material begin to soften up and become more elastic. Once you do this for each arm your Snappi® Diaper Fastener is ready for use.

Additional Information
Choose Packet Pieces

1 Piece, 2 Pieces, 3 Pieces

Care Guide


  • Wash the Snappi® in warm water with mild soap.
  • Rinse thoroughly and let it air dry.


  • Boil the Snappi® in water for 5 minutes to sterilize.
  • Do not use bleach or any harsh chemicals.


  • Store the Snappi® in a dry place.
  • Keep it away from direct sunlight and heat.


  • Stretch the Snappi® before first use to ensure it's not too tight.
  • Hook one side of the Snappi® onto the diaper, pull it across the diaper, and hook the other side.
  • Adjust the Snappi® as needed to fit snugly but comfortably.


  • Check the Snappi® regularly for any signs of wear and tear.
  • Replace the Snappi® if any teeth are missing or broken.
  • Do not leave the Snappi® within reach of children.

By following these care instructions, your Snappi® diaper fastener will last longer and remain in good condition for repeated use.